Maintenance; Blade Sharpening - infaco Electrocoup F3015 Original Instructions Manual

MAINTENANCE

For all these operations you must disconnect the pruning shears.

Blade sharpening

GOOD SHARPENING
YES
Sharpening must be done on the flat,
on the
keep the same angle of penetration throughout.
GOOD pEnEtration
Results:
• A clean cut
• Increased cutting capacity
• Improved cutting speed
• Greater autonomy
• Reduced mechanical fatigue
• Blade's improved life expectancy
• Normal motor temperature
• Higher yield
To optimise your blades to the maximum and obtain a better yield from your ELECTROCOUP, we
recommend using our A48v3 blade sharpener. You will also save considerable time in your daily
sharpening.
16
2 red slanted lines, in order to
After 10 days
After 30 days
Sharpening every 2 hours
NO
If sharpening is only done on the cutting edge, after a
few sharpening operations, the fine section of the blade
will disapear and you will lose the angle of penetration.
Results:
• Leaves strips of bark which get stuck in the
blade
• Reduced cutting capability
• Requires more energy even for simple cuts
• Uses more electricity therefore less autonomy
• Greater mechanical strain
• Blade wears out quicker
• More overheating
• Time wasted
BAD SHARPENING¢
BAD pEnEtration
After 10 days
After 30 days