Changing The Blade; Cleaning And Disinfecting The Cutting Head; Yearly Maintenance; Transport Precautions - infaco Electrocoup F3015 Original Instructions Manual

Changing the blade

For all these operations you must disconnect the pruning shears.
1. Using the phillips head tip on the tool, unscrew the two n°1 screws and remove cover n°2.
2. Using the other tip of the special tool, remove screw n°3 and the elastomer washer n°4.
3. Again using the special tool, remove screw n°5 and washer n°6.
4. Remove the blade n°7. Replace the blade.
5. If necessary, clean around the pinion (warning: do not use chemicals).
6. Fit the new blade on the pruning shears.
7. Fit washer n°6 then screw and adjust the tightness of bolt n°5 until the tool clicks (see page 16).
8. Fit elastomer washer n°4 on screw n°3 and tighten screw n°3.
9. If necessary, lubricate the blade teeth using graphite grease.
10. Fit cover n°2 on the pruning shears and screw both n°1 screws.
7
5
3
2
6
4
CLICK !
1

Cleaning and disinfecting the cutting head

The cutting head can be cleaned to remove any residue (sap, etc.).
To do this, we recommend using the INFACO ecological spray can reference B500N.
It is also possible to disinfect the cutting head to prevent any diseases spreading on the wood.
To do this, we recommend avoiding the use of corrosive products that could damage the device.
Don't hesitate to contact us so that we can assist you in selecting your products.

YEARLY MAINTENANCE

At the end of the pruning season, remember to put the batteries in sleep / winter mode to prevent their
premature ageing during storage (see page 11). We strongly recommend that you send your units for
an annual maintenance/service every year. This will ensure proper functioning of your unit and gives an
opportunity to have your units checked and assessed.

TRANSPORT PRECAUTIONS

The case is certified for the transport of Lithium batteries > 100W (UN 3480-3481 standard). However,
some rules must be followed when shipping using a transporter:
The unit must be fully disconnected (pruning shears, coil, and battery).
It is compulsory for the battery to be placed in the housing provided in the case. The case must be taped /
shut correctly to prevent any risk of it opening.
18