Powering On; Precautions For Use - infaco Electrocoup F3015 Original Instructions Manual

Powering on

When the device is running, always keep your hands away from the cutting head.
2.
Press the ON/OFF button on the pruning shears for
1 second until the LEDs come on. The pruning shears are
ready to use when the LED power supply flashes green.
x2

PrEcautions for use

Before starting the working day, make sure the battery is sufficiently charged (3 LEDs on the pruning
shears).
Always disconnect the pruning shears from the power cord for all operations other than trimming.
MOST IMPORTANTLY, REMEMBER TO DO SO WHEN SHARPENING OR LUBRICATING.
Check that the blade is correctly tightened every morning (see page 17).
Do not leave the pruning shears and/or the battery on the ground, and do not expose them to bad
weather conditions.
Make sure the battery's protective plastic casing is not cracked and is free from any physical damage
When working it is normal that the battery temperature rises (as during charging).
Recommended operating temperature: -5 to 35°C Use outside this temperature range may reduce
the tool's performances.
In wet weather, it is imperative to carry the battery under waterproof clothing to keep it protected
from the rain.
After using the tool in wet conditions or in a damp environment, it is strongly recommended to store
the (disconnected) device outside its case in a warm, dry and ventilated place.
Keep the cord away from the cutting zone.
1. Using the socket locators, first connect the coiled
cord to the battery and then to the pruning shears.
It is imperative to follow the connecting order when
powering on the device.
3. Press the trigger twice to start up the pruning
shears.
1s
7