Adjusting The Half-Opening / Blade Crossing; Accessing The "Adjustment" Mode; Adjusting The Half Opening Or The Blade Crossing Ratio - infaco Electrocoup F3015 Original Instructions Manual

ADJUSTING THE HALF-OPENING / BLADE CROSSING

When the device is operational, always keep your hands away from the cutting head.

Accessing the "adjustment" mode

You can adjust the position of the blade to half-open and the blade crossing ratio relative to the hook at
your convenience. To do this you must access the pruning shears "adjustment" mode.
The adjustment mode is only accessible on the first blade closure after the pruning shears have
been powered on.
1. Press the pruning shears ON/OFF switch for 1 second and then
release the button as soon as the LEDs light.
The pruning shears are ready to use when the power supply LED
flashes green.
2. Press the trigger twice to start up the pruning shears.
3. At the first blade closure keep the trigger in the closed position
until the 3 charge indicators flash.
4. The pruning shears are now in the "adjustment" mode. Release the
trigger. The blade opens slowly.

Adjusting the half opening OR the blade crossing ratio

Once the pruning shears are in the "adjustment" mode,
the half-opening OR the blade crossing ratio can be set.
The pruning shears have pre-set blade positions:
- 10 half-opening positions.
- 10 blade crossing ratio positions.
1. Once the pruning shears are in "adjustment" mode, press and hold
the trigger to get the first pre-set adjustment position.
2. Press and hold the trigger to move from position to position.
3. If you overshoot the required position, release the trigger to
return to the open blade position and begin the procedure from the
beginning.
4. Once the half-open or blade crossing ratio has been set, keep the
trigger pressed in.
5. Validate the position by flicking the half-open switch once.
6. To confirm the validation, the blade must open and the pruning
shear LEDs must be on and green (not flashing). The pruning shears
are ready for normal use.
7. To carry out another adjustment, power off and begin the operation from "accessing the
adjustment mode".
14
1s
x2
Half-opening
adjustment zone
Blade crossing ratio
adjustment zone
x1