Set); System Turns On - Pylontech PowerCube-X1 Operation Manual

The BMS's first five bits must set in below <BMS's Address Configure
Table>. The last BMS's terminal resistance must set in "1" (X=1), and other
BMS's terminal resistance must set in "0".
The address is configured follow ASCII code: ("X" is terminal resistance).
BMS's Address Configure Table:
Battery
Address Bit
String
1 10000X
2 01000X
3 11000X
4 00100X
5 10100X
6 01100X
7 11100X
8 00010X
Note: The above setting is following standard. But some PCS or Inverter's address is changeless,
can't be set. In this case the address setting must follow such equipment's address. If the address
setting is failed, please contact the distributor or Pylontech.

3.6.4 System turns on

Double check all the power cables and communication cables. Make sure the voltage of the
PCS is same level with the battery system. Check all the power switch of every battery system is
OFF.
Warning: MBMS must be turned on after all battery strings self-check finish.
(1) Check the UPS is turned on if configured. And the UPS is power supplying.
(2) Switch the external power or PCS on, make sure all the power equipments can work normally.
(3) Turn on the 1 BMS (Battery Control Modules) of battery string:
st
The second BMS must be operated after the first battery string's self-check is successful.
From 1st BMS to the last BMS Then turn on the battery strings on one by one from 1st BMS to the
last BMS.
Turn on the "POWER RELAY SWITCH":

Battery
Address Bit
String
9 10010X
10 01010X
11 11010X
12 00110X
13 10110X
14 01110X
15 11110X
16 00001X
15 / 31
Battery
Address Bit
String
17 10001X
18 01001X
19 11001X
20 00101X
21 10101X
22 01101X
23 11101X
24 00011X
Battery
Address Bit
String
25 10011X
26 01011X
27 11011X
28 00111X
29 10111X
30 01111X
31 11111X
32 00000X
18BISV0101