Control Module (Bms) And All Battery Modules Install Into The Rack; Install The Mbms Into A 19' Standard Rack [On The Top Of Bms, Or Use The Rack Configured By User]; Cables Connection; Pay Attention Terms - Pylontech PowerCube-X1 Operation Manual

3.5.4 Control Module (BMS) and all Battery Modules install into the Rack

Install the buckle nuts. The position of nuts must meet the position of the control module (BMS)

and all battery modules.
Install the control module (BMS) and all battery modules in. Each module uses 4 screws to fix

it. Refer to chapter 3.5.1
3.5.5 Install the MBMS into a 19' standard rack [On the top of BMS, or use the rack configured
by user]
Install the buckle nuts. The position of nuts must meet the position of the MBMS.

Install the MBMS in. Uses 4 screws to fix it.


3.6 Cables connection

3.6.1 Pay attention terms:

Danger: The battery system is high voltage DC system. Must make sure the grounding of the rack
is stable and reliable.
Danger: All the plugs and sockets of the power cables must be orange to orange and black to
black. Otherwise it will cause personal injury.
Danger: No short circuit or reserved connection of the battery system's anode and cathode.
Caution: Wrong communication cables connection will cause the battery system failure.
Grounding
The PowerCube-X1 modules' grounding is based on metal directly touch between
the module's surface and rack's surface. So it needn't grounding cables at all. If uses
normal rack, it can remove the paint at the corresponding place.
3.6.2 Cables Connection
Note: Power cable uses water-proofed connectors. It must keep pressing this
Lock Button during pulling out the power plug.
CAN Communication Mode between MBMS and BMS (battery string qty. ≤6 set) (battery
string qty. ≤6 set)
When system configured PowerCube-X1 ≤6 set. The communication between PowerCube-X1s
uses CAN cascade communication mode. The communication between the MBMS and the BMS
of 1 PowerCube-X1 uses CAN communication mode.
st
13 / 31
18BISV0101