Elcometer 224 Operating Instructions Manual page 29

R
REVIEW BATCHES
Displays contents of any batch.
Press the left/right arrows to select the batch you want to review, then
press OK.
The status area in the bottom half of the screen displays the batch
number, batch type and number of readings in the batch.
Press to switch the status area on/off.
Press the up/down arrows to scroll.
SET LIMITS
Upper and lower values can be set by the user to monitor specification
values.
To activate limits tick the LIMITS ON box.
To set the UPPER and LOWER limit values move the cursor to the limit
required and press SEL.
The gauge will display the current settings.
Adjust the values with Up/Down softkeys. When the correct value is displayed, press OK to enter.
With LIMITS ON activated, an out-of-limits reading will be indicated by a triple beep. A reading within limits
is indicated by a single beep. Out-of-limits symbols and will be stored in the batch and can be seen
when the batch is reviewed.
26