Flowchart To Remedy The Troubles - Renesas Emulation Probe M30850T-EPB User Manual

Chapter 6. Troubleshooting

6.1 Flowchart to Remedy the Troubles

Figure 6.1 shows the flowchart to remedy the troubles from when power to the emulator is activated
until the emulator debugger starts up. Check this while the target system is disconnected. For the latest
FAQs visit the Renesas Tools Homepage.
Figure 6.1 Flowchart to remedy the troubles
http://www.renesas.com/eng/products/mpumcu/toolhp/faq/m16c80/m16c80_e.htm
Turning on PC7501
Upper panel LED of PC7501
Normal
Init dialog box of emulator
debugger displayed
Normal
EMEM dialog box of emulator
debugger displayed
Normal
Program window of emulator debugger displayed
Not normal
1. Check emulator system connections.
See, "3.7 Connecting the PC7501" (page 36).
2. Redownload the firmware.
See "4.2 Downloading Firmware" (page 50).
3. Restart the PC7501 system.
Not normal/Error displayed
1. Check the operating environment etc. of the emulator
debugger.
See the user's manual of the emulator debugger.
2. Reinstall the emulator debugger.
Not normal/Error displayed
See "6.2 (3) EMEM Dialog Box is Not Displayed at Debugger
Startup (Target Not Connected)" (page 69).
Error displayed
See "6.2 (4) Errors Occur at Debugger Startup (Target
Connected)" (page 69).
( 66 / 76 )