Assembly - Broaster 1600 Service Manual

4. Remove two cover bolts (12).
5. Lift yoke bar up. The cover (4) and
spacer block (5) will remain.
6. Remove lifter box (13).
7. Rotate cover handle to the OPEN
position.
8. Locate grooved pin (14) hole in the flat
of the cam (3).
Be sure to note how the
handle and cam are
removed. Use a stiff wire to tie the han-
dle and cam together after removal.
9. Use a 1/8 inch punch to remove
grooved pin. Remove handle and cam.
10. Clean lifter box, handle, cam and yoke
bar where lifter box slides up and
down.

ASSEMBLY

Continued:
6-5
broaster.com Manual #14680 3/99 Rev. 5/14
1. Install cam (3) into yoke bar.
2. Install handle (2) through splash guard,
into yoke bar then into the cam.
3. Align holes in handle and cam then
install a new grooved pin (14). Be sure
the grooved pin is installed flush with
the cam.
4. Lubricate inside of yoke bar where
lifter box slides up and down.
5. Lubricate lifter box then install lifter
box into the yoke bar.
6. Lower assembly over the cover (4) and
spacer block (5).