Cover And Yoke Assembly; Check Cam Operation - Broaster 2400 Service Manual

COVER AND YOKE ASSEMBLY

1. Install cam (3) into yoke bar.
2. Install handle (2) through splash guard,
into yoke bar then into the cam.
3. Align holes in handle and cam then
install a new grooved pin (14). Be sure
the grooved pin is installed flush with
the cam.
4. Lubricate inside of yoke bar where
lifter box slides up and down.
5. Lubricate lifter box then install lifter
box into the yoke bar.
6. Lower assembly over the cover (4) and
spacer block (5).
7. Rotate cover handle to the CLOSED
position.
reassembly (see Centering Cover under
ADJUSTMENTS).

CHECK CAM OPERATION

When handle is rotated, cam (3) moves
cover (4) in or out of the cooking well. Cam
and spacer block (5) lock the cover when
pressure in cooking well pushes up on the
cover.
5-6
broaster.com Manual #17280 1/15 Rev 6/15
8. Align holes in lifter box, spacer block
and cover.
9. Install new cover bolts but do not
tighten.
Bolts will be tightened
when centering cover at