Mitsubishi Electric MELSEC L Series Manual page 59

3
ANALOG OUTPUT MODULE REPLACEMENT
Between the I/O terminal and programmable controller power supply: Photocoupler
Between output channels: Not insulated
Between external power supply and analog output: Transformer
Between the I/O terminal and programmable controller power supply: 500VACrms, for 1 minute
Between external power supply and analog output: 500VACrms, for 1 minute
Between the I/O terminal and programmable controller power supply: 500VDC, 10M or higher
(I/O assignment: intelligent 16 points)
R1.25-3 (Solderless terminals with an insulation sleeve cannot be used.)
L60DA4
16 points
18-point terminal block
2
0.3 to 0.75mm
0.16A
24VDC +20%, -15%
Ripple, spike 500mV or lower
P-P
0.18A
4.3A, 1000µs or less
0.20kg
: Compatible, : Partial change required, ×: Incompatible
Compatibility Precautions for replacement
The number of occupied I/O points
is changed to 16 points.
×
× Wiring change is required.
×
×
An external power supply (24VDC)
×
is required.
×
3
- 6