Mitsubishi Electric MELSEC L Series Manual page 172

5
HEATING-COOLING TEMPERATURE CONTROL MODULE/TEMPERATURE
Address (hexadecimal)
CH1 CH2
3E 5E
3F 5F
AB AC
B1 B2
*1 For the A1S64TCRT(BW)-S1, this area is prohibited to use.
Point
Default values for the A series modules and L series modules may be different.
To apply an A series program using a default value to an L series module, review the program.
For details, refer to the user's manual for the L series module used.
5
- 57
A1S64TCTT(BW)-S1, A1S64TCRT(BW)-S1
CH3 CH4
7E 9E
System area (Use prohibited)
7F 9F
A0 Alert alarm 1 mode setting
A1 Alert alarm 2 mode setting
A2 Alert alarm 3 mode setting
A3 Alert alarm 4 mode setting
A4 Alert dead band setting
A5 Number of alert delays
Number of delays for heater disconnection/current
A6
error detection when output is turned off
A7 Temperature increase complete range setting
A8 Temperature increase complete soak time setting
A9 PID continue flag
AA Heater voltage correction function setting
AD AE Standard heater current value
AF Transistor output monitor ON delay time setting
B0 CT monitor method switch
B3 B4 Manipulation value (MV) (0 to 4000)
B5 System area (Use prohibited)
Cold junction temperature correction selection
B6
(This area can be used with the software version F or
later.)
Name
*1
Read/write
–
R/W
R
–
R/W