Mitsubishi MELSEC Q Series Programming Manual page 279

Operation Error
(1) In the following case, an operation error occurs, the error flag (SM0) turns ON, and an error
code is stored into SD0.
• When values other than 0 to 9 are designated to any digits of
The error above can be suppressed by turning ON SM722.
However, the instruction is not executed regardless of whether SM722 is turned ON or OFF
if the designated value is out of the available range.
For the BINP/DBINP instruction, the next operation will not be performed until the command
(execution condition) is turned from OFF to ON regardless of the presence/absence of an
error.
Program Example
(1) The following program converts the BCD data at X10 to X1B to BIN when X8 is ON, and stores it
at D8.
Can be used
in other purposes.
Input
power supply
[Ladder Mode]
Programmable Controller input module
S
BCD digital switch
[List Mode]
Step Instruction
BIN(P),DBIN(P)
(Error code: 4100)
Device
6-77
1
2
3
4
4
6
7
8