Caution And Notes; Intended Use - ASCOM Myco 2 User Manual

User Manual
Ascom Myco Smartphone
For software download and parameter setup, refer to the Configuration Manual, Ascom Myco
Smartphone.
NOTE: Some functions are dependent on the PBX and protocol (SIP) versions, and
your system may not support all functions described in this document. For
more information about your system, please contact the person (or
department) responsible for the system in your organization, or contact your
supplier.
1.1

Caution and Notes

Please read and adhere to all of the cautions listed throughout this manual.
A WARNING is provided to outline items that if not followed, may result in death or serious
injury to the patient or damage to the equipment.
A CAUTION is provided to alert the user that special care should be taken for the safe and
effective use of the handset.
A NOTE is provided when additional general information is available.
1.2

Intended Use

Ascom Smart Device Alert Handling Software is intended for the electronic display of alarm
notifications and other data originating from connected medical devices via Ascom medical
devices to healthcare professionals, in order to aid monitoring of patients.
Ascom Smart Device Alert Handling Software is intended to be used as a secondary means of
displaying alarm notifications and other medical device data, and is not intended to be used as
a replacement or substitute for direct viewing of data on connected devices.
The Ascom Smart Device Alert Handling Software is not intended to be used in connection
with active patient monitoring to be relied upon in deciding to take immediate clinical action, or
for diagnostic purposes.
Furthermore, the Ascom Smart Device Alert Handling Software is not intended to control or
alter the functions or parameters of connected medical devices.
The Ascom Smart Device Alert Handling Software is intended for use by professional clinical
and non-clinical personnel and relies on proper use and operation of both the communication
infrastructure in place at the healthcare facility and the display devices used.
The Ascom Smart Device Alert Handling Software components shall be installed on specified
hardware and operating system and relies on the healthcare facility to provide specified
medical IT network and communication infrastructure.
Staff using the Ascom Smart Device Alert Handling Software must receive training in order to
be able to use the software in a correct and responsible fashion. Please contact your Ascom
service representative for additional information.
14 May 2018 / Ver. K
1. Introduction
TD 93066EN
2