Graph Options - Dent ELITEpro XC Operator's Manual


Double-clicking the graph also provides a Maximize feature that enables you to increase the visual
representation of the graph.

Graph Options

The Graph Options dialog box allows you to set several defaults when a new graph is created.

Select the Show graph data cursor check box to turn on the data cursor. The data cursor is a vertical
line that appears on a graph and is used to help visually line up multiple graphs. It can also be turned
on and off at any time while viewing a graph by right-clicking the mouse button.
If there is more than one variable plotted, all values are shown on the screen. The values are not
labeled but are shown in the same order that the variables appear in on the graph.
The data cursor may be moved by using the left-right arrow keys or by using the mouse to left click
on the cursor and drag it to the desired location.
NOTE: You will not see the cursor move when using the mouse until releasing the left mouse button.

Select the Show graph data points checkbox to display the specific point at which the data was
collected on the graph. It directly correlates to the Data Interval timeframe that was selected in the
Setup Table File, e.g. 15 seconds, 5 minutes, 1 hour, etc.

Select the Show analysis values checkbox to display the average, maximum, and minimum value for
each parameter plotted on a graph. The values appear to the right of the graph where the graph
labels are also shown. If desired, by unchecking the Show analysis values box, the values will not be
shown (or printed) on the graph.
DENT Instruments
ELITEpro
Best Practices
88