Understanding The Logger Lists - Dent ELITEpro XC Operator's Manual

The file created is labeled autopoll.log and is automatically saved to whatever folder contains the
ELOG application program (typically C:\Users\UserName\Documents\DENT\ELOG\Data). The folder
where the file is saved may not be changed except by moving the ELOG application too.
As subsequent polling sessions are completed, the autopoll.log file is automatically updated and the
new contact reports are appended to the existing .log file. The maximum size of the autopoll.log file
is 1 Megabyte. If this limit is exceeded, AutoPoll automatically changes the existing .log file into a
.bak (backup)and starts a new .log file. If there is already an existing autopoll.bak file, the existing
file is deleted and replaced by the new autopoll.bak file.
Autopoll.log is a text format document (.txt) and may be opened by a word processor or any
application that reads ASCII files from which it may then be viewed or printed.

Clear AutoPoll Log
Can be used to clear the current call log.
NOTE: Once cleared, the call log information cannot be retrieved.
U L
NDERSTANDING THE
Logger Lists are used to maintain information about groups of loggers (the lists) related to the
communication medium, including the IP address and a schedule of calls to be made to the logger by the
host computer. This information can be used for manual connecting and by the AutoPoll program. A
Logger List may have as few as one logger in it or hundreds.
Logger Lists are accessed through the File > Open (or New) > Logger List File command. Selecting Open
will bring up a folder from which to select an existing Logger List to edit or use. Selecting New will bring
up a blank Logger List as shown below:
Serial Number is the 9-digit logger serial number. If the serial number entered here does not match the
serial number of the logger that AutoPoll connects to, the data will be retrieved but an error will be
noted in the Call Log.
Description (optional) is a 20 character description of the load monitored
Setup is where additional information about connecting to the logger is kept.
Add Logger is used to add a new, blank line at the bottom of the Logger List to create new entries for
additional loggers.
DENT Instruments
ELITEpro
L
OGGER ISTS
Appendices
111