Dent ELITEpro XC Operator's Manual page 57

CT Connections
Voltage Lead
Connections
ELITEpro XC End View of CT and Voltage Lead Connections
2) Apply the CTs to the phases being monitored observing proper CT orientation.
3) If there is an arrow on the CT label, the label should point towards the load. Otherwise, use the
instructions printed on the CT, for example: "This Side Toward Load."
4) Connect the voltage leads to the different phases. Connect the Neutral wire first, then the remaining
voltage sense (phase) wires.
DENT Instruments
ELITEpro
Best Practices
57