Dent ELITEpro XC Operator's Manual page 47

For a description of the Recorded Values and their formulas for the Calculated Power Channels, see
Calculated Power Channels.
The following options are available for configuring Physical Power Channels.
Name Name the channel so it describes the location or
item being monitored, such as "Water Heater"
V High High-side voltage. This is the "high" reference
voltage that will be measured with respect to
V Low
PT Ratio Potential Transformer turns ratio. This is used
measure AC voltages greater than 600V. The
Type
Amps Depends on the type of CT selected. Displays
Phase Shift Compensate for CT Phase Shift with this setting.
Volts
Amps
KW
KVA
PF
KVAR
See Power Measurement—Connecting CTs and Configuring Channels for information on how to
properly configure the Setup Table for single-phase 2-wire, single-phase 3-wire, 3-phase 3-wire, and
3-phase 4-wire services.
DENT Instruments
ELITEpro
Physical Power Channel Options
or "Pump L1 Phase." A maximum of 20
characters is allowed.
the reference "low" voltage, V Low.
Low-side voltage; reference for AC voltage.
when a step-down transformer is needed to
default is 1.000.
This is the type of CT connected to the
ELITEpro XC
the value entered in the CT Size screen.
Default setting is 1.1 degrees.
To record any or all of these values use the
menu to select an option.
Best Practices
Optional
Choices are: L1, L2, L3, Neutral.
Choices are: L1, L2, L3, Neutral.
Choices are: MilliVolt or RōCoil.
Choices are: Average, Minimum, or
Maximum. In addition the integrated
hourly value in an option where
appropriate.
47