Best Practices; Creating And Using The Logger Setup Tables; Create A New Setup Table - Dent ELITEpro XC Operator's Manual

BEST PRACTICES

Creating and Using the Logger Setup Tables

The ELITEpro XC requires that it be configured for use by first creating a "Setup Table" file and then
loading the file into the meter. The ELITEpro XC is a flexible meter that can monitor a wide variety of
parameters over a wide range of currents, voltages and service types. This requires that you determine
what is recorded and at what intervals.
Setup Tables are created using the ELOG software and saved to the computer with a .sut file extension
appended to the name. A .sut file may be:

Loaded into the ELITEpro XC immediately or at a later time but prior to beginning a monitoring
session

Sent to any number of loggers

Retrieved from an ELITEpro XC, modified and saved, and resent to the logger
C N S T
REATE A EW ETUP
A new setup table can be created for any of the devices compatible with the current version of ELOG 15.
This includes a variety of DENT Instruments legacy products in addition to the ELITEpro XC.
If the logger is not connected and communicating with the computer, setup tables can still be created
and saved to the computer.
1) Select File > New > Setup Table File and click OK.
If your computer is currently communicating to an ELITEpro XC, the ELOG software assumes the new
setup file is for the connected device. Selecting New displays a setup table with the default parameters.
If no ELITEpro XC or other logger is communicating with the computer, the Select A Setup Table Type
dialog box displays.
DENT Instruments
ELITEpro
ABLE
38