Dent ELITEpro XC Operator's Manual page 120

b) If necessary, change the Port Number. The factory default is 3001 and will usually work in most
cases.
The use of the Subnet Mask and Gateway Address are outside the scope of this manual. If
needed, ask the network administrator for assistance
c) Click Update Logger. The following message displays:
d) Select OK then remove all power to the logger including the USB cable to perform a power cycle.
e) (Skip this step if Static IP was used.) If DHCP was selected, reconnect the logger using the USB
cable and use Logger > Communication > Logger Ethernet Setup... to determine what IP address
was assigned by the network router to the logger. Note this IP address and disconnect from the
USB connection.
5) Connect an Ethernet cable from the network into the Ethernet port on the side of the logger.
6) Click the Ethernet or Wi-Fi Connection speed button on the toolbar to reconnect via
Ethernet. The Network Connect dialog box displays:
7) Enter the Network IP Address and Port Number if it is not automatically populated. Select OK to
proceed and establish your Ethernet connection.
NOTE: If you do not know your Network IP Address or Port Number, click the Scan button on the
Network Connect window. ELOG will scan the network for loggers and display them in the Logger
Selection dialog box. Look for the serial number of the logger to determine which connection point is
yours. The logger's serial number can also be found on the back of the logger. Select your logger in the
Logger Selection dialog box and click OK, and then OK again in the Network Connect window.
DENT Instruments
ELITEpro
Appendices
120