Logging On Duofern Devices - RADEMACHER DuoFern 9484 Instruction Manual

i

17.1 Logging on DuoFern Devices

1.
Switch the desired DuoFern device to the registering mode
(please refer to the relevant instruction manual).
2.
+
AUTO
120 sec.
3.
4.
5.
Register the next DuoFern device.
For this, repeat points 1 to 2 or terminate the registration.
Pay attention to the middle indicator light
The middle indicator light lights up red if the registration process
fails, for example if:
◆ 20 DuoFern transmitters have already been registered
◆ An unsuitable device is registered
1 sec. Enable the registering mode of
the DuoFern Motion Detector 9484.
Simultaneously press and hold
the buttons for 1 second.
The registering mode remains
active for approx. 120 seconds
During the registering process, the
middle indicator light flashes green.
After successful registration, the middle
indicator light lights up for approx.
4 seconds and the connected appliance
is briefly switched on or off.
EN
53