RADEMACHER DuoFern 9484 Instruction Manual page 48

i
15. Setting the Brightness Set Limit
Increase / decrease the brightness set limit
1.
4 sec.
2.
Tap on
3.
Tap on
Adopting the current brightness as the set limit
If required, as an alternative to the setting, the current brightness
can be adopted as the set limit.
i
1.
8 sec.
2.
48
Press and hold the button.
+ After approx. 4 seconds, you can increase
MANU
the set limit by additionally tapping on
the MANU button.
+ After approx. 4 seconds, you can decrease
AUTO
the set limit by additionally tapping on the
AUTO button.
Ensure that the sensor panel is not covered during
the measurement.
Press and hold the button for 8 seconds.
The set limit is displayed after approx.
4 seconds (example).
EN