Omron CS1W-CT041 Operation Manual page 46

@*+'%<<%'()*
2. While making sure to align the Unit properly with the (bus-) connectors, tighten
the mounting screws securely using a flat-blade screwdriver with a maximum
tightening torque of 0.4 Nm.
Note To remove the Unit, first loosen the mounting screws.
Leave enough space below each Rack, as shown in the following diagram to be
able to mount or remove Units in a later stage.
Flat-blade screwdriver
Mounting screw
20 mm min.
Backplane
20 mm min.
Section 2-2
&$