Omron CS1W-CT041 Operation Manual page 128

H#>)"D-=<<)$%'()*
Word
m+138, m+139 00-15
m+140, m+141 00-15
m+142, m+143 00-15
m+144, m+145 00-15
m+146 00
01
02-15
m+147, m+148 00-15
m+149, m+150 00-15
m+151, m+152 00-15
m+153 00-15
m+154 00-07
08-15
m+155 00-03
04-15
m+156, m+157 00-15
m+158 to m+164 00-15
Bit Item
Rate-Range 1
Lower Limit
Rate-Range 1
Upper Limit
Set Pattern
Rate-Range 1
Reset Pattern
Rate-Range 1
Rate-Range 0 Enable
Rate-Range 1 Enable
---
Range / Comparison
Enable Data
Output Set Pattern
Output Reset Pattern
Hysteresis
# Ranges /
Comparison Values
---
Memory Area
---
Memory Address
---
Rate-Range 1 Lower Limit
Rate-Range 1 Upper Limit
Output Set Pattern Rate-Range 1
Output Reset Pattern Rate-Range 1
Enable (=1) / Disable (=0) Rate-Range 0
Enable (=1) / Disable (=0) Rate-Range 1
Not used
Enable Ranges / Comparison Values (1=Enabled,
0=Disabled) (depending on Unit in Range /
Comparison Mode).
Bits set for non-existing ranges or CV's will be ignored
Output [0-31] Set Pattern for Comparison Mode
1= set, 0 = no change
Output [0-31] Reset Pattern for Comparison Mode
1= reset, 0 = no change
Define required Hysteresis (0000 ≤ Hysteresis ≤ 00FF
counts). Hysteresis (=0) means Hysteresis is OFF.
Set number of Ranges/ Comparison Values
[0, 32 ]
(BCD)
Not used
Memory Area where Range / Comparison Data is stored:
0 = EM (=default)
1 = DM
Not used
Beginning Address (in EM/DM) where first Range /
Comparison Data is stored [00000, 32760
Not used
Section 4-2
Function
(BCD)
]
$$&