Omron CS1W-CT041 Operation Manual page 126

H#>)"D-=<<)$%'()*
Word
m+93, m+94 00-15
m+95, m+96 00-15
m+97, m+98 00-15
m+99, m+100 00-15
m+101 00
01
02-15
m+102, m+103 00-15
m+104, m+105 00-15
m+106, m+107 00-15
m+108 00-15
m+109 00-07
08-15
m+110 00-03
04-15
m+111, m+112 00-15
m+113 to m+119 00-15
Bit Item
Rate-Range 1
Lower Limit
Rate-Range 1
Upper Limit
Set Pattern
Rate-Range 1
Reset Pattern
Rate-Range 1
Rate-Range 0 Enable
Rate-Range 1 Enable
---
Range / Comparison
Enable Data
Output Set Pattern
Output Reset Pattern
Hysteresis
# Ranges /
Comparison Values
---
Memory Area
---
Memory Address
---
Rate-Range 1 Lower Limit
Rate-Range 1 Upper Limit
Output Set Pattern Rate-Range 1
Output Reset Pattern Rate-Range 1
Enable (=1) / Disable (=0) Rate-Range 0
Enable (=1) / Disable (=0) Rate-Range 1
Not used
Enable Ranges / Comparison Values (1=Enabled, 0=
Disabled) (depending on Unit in Range /
Comparison Mode).
Bits set for non-existing ranges or CV's will be ignored
Output [0-31] Set Pattern for Comparison Mode
1= set, 0 = no change
Output [0-31] Reset Pattern for Comparison Mode
1= reset, 0 = no change
Define required Hysteresis (0000 ≤ Hysteresis ≤ 00FF
counts). Hysteresis (=0) means Hysteresis is OFF.
Set number of Ranges/ Comparison Values
[0, 32 ]
(BCD)
Not used
Memory Area where Range / Comparison Data is stored:
0 = EM (=default)
1 = DM
Not used
Beginning Address (in EM/DM) where first Range /
Comparison Data is stored [00000, 32760
Not used
Section 4-2
Function
(BCD)
]
$$$