Table of Contents
Advertisement
;4#"%'(*2-!")$#.&"#-:&(.#<(*#+
Unit Configuration
3. Install and wire the Unit. Refer to 2-2 "Installation" and 2-3 "Wiring" for further
details.
4. Turn ON the Power to the PLC.
5. Create the I/O table. The I/O table can be created by using CX-Programmer
Support Software or a Programming Console.
After the I/O table is created in step 5, you have to configure the Unit if you have
chosen for Configuration 2 or 3 in step 1. Configuration is done by making the
appropriate DM-settings. The Unit can be configured by using CX-Programmer
Support Software or a Programming Console. Two Programming Consoles can be
used with the CS1-series CPU Units: the C200H-PRO27-E and the CQM1-
PRO01-E. CS1W-KS001 Key Sheet must be used for both.
Depending on the Configuration (1, 2 or 3) that you specified in step 1, you should
continue with the corresponding step of the configuration-process:
Section 1-5
Power ON
CX-Programmer
Programming Console
%$
Advertisement
Chapters
Table of Contents
