Cembre HT-TC0851 Operation And Maintenance Manual page 5

- Reference symbol
- Repère fi xe
- Ideogram reference
- Reference ideogram
- Simbolo de referencia
- Simbolo di riferimento
LOCK
- Rest - Release - Operating
position position
- Repère - Repère de - Repère de
de repos décompression
- Ruhestellungs - Druckablass - Arbeits
position position
- Posición - Posición - Posición
de liberación
de reposo
- Posizione - Posizione - Posizione
di rilascio
di riposo
FIG. 1 OVERALL VIEW
VUE D'ENSEMBLE
GLOBALANSICHT
VISTA DEL CONJUNTO
VISTA D'ASSIEME
27
25
position
travail
04 59
position
de trabajo
di lavoro
3.6) Blade replacement
After extended use, the blades may loose their cutting edge.
Replace the blades as follows:
3.6.1) Lower blade:
30
– Press latch (33) and open upper blade assembly (27).
– Pump the moveable handle (59) to make the lower blade (25) advance until fi xing pin
(08) is visible on ram.
33
– Remove fi xing pin (87) and remove the lower blade (25).
– Insert new blade and secure with fi xing pin (87).
Warning: before closing the upper blade assembly, release the oil pressure and retract
the lower blade, otherwise the blade may hit the lower blade edge and damage it.
36
3.6.2) Upper blade:
– Press latch (33) and open upper blade assembly (27).
– Remove circlip (93) and pivot (92).
– By an hexagonal 13 mm, undo M8 nuts (94) and remove two studs (97), blade guide
(95) blade spacer (96) and upper blade (27), noting the order of assembly.
– Fitting the new blade is a reversal of the above.
4. WARNING
13
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performanceof
the tool:
4.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove
any residual, especially close to pivots and moveable parts.
4.2) Storage
When not in use, the tool should be stored and transported in the plastic case, to prevent
damage.
These plastic case VAL P7, is dimensioned 727x202x115 mm (28.6x8x4.5 in.) and weights
1,3 kg (2.9 lbs).
4.3) Head rotation
For ease of operation, the tool head can rotate through 180°.
Warning: Do not attempt to turn the head if the hydraulic circuit is pressurised.
27 4
(Ref. to Fig. 2)
(Ref. to Fig. 3)
ENGLISH