Replacing The F-Cm As-I Safety St Module - Siemens SIMATIC ET 200SP Manual

Alarm, fault, and system events
8.4 Replacement of defective devices
8.4.3

Replacing the F-CM AS-i Safety ST module

When the F-CM AS-i Safety ST module is replaced, the new device automatically receives
all necessary settings from the head module (IM) of the ET 200SP and the coding element in
the BaseUnit.
When replacing an F-CM AS-i Safety module with firmware V1.0.0, the instructions in
Section "DS 206 Diagnostic data record (Page 69)" must be observed.
For more information, see Manual "ET 200SP Distributed I/O System
(http://support.automation.siemens.com/WW/view/en/58649293/0/en)
92
Fail-safe Module F‑CM AS‑i Safety ST (3RK7136‑6SC00‑0BC1)
Manual, 03/2017, A5E03957059020A/RS-AB/002