Safety Instructions - Siemens SIMATIC ET 200SP Manual

Safety instructions

Important safety instructions
Failure to observe this information may result in death, severe injury, and serious property
damage.
For operation in Pollution Degree 2 environment.
Failure to observe this information may result in death, severe injury, and serious property
damage.
When used in hazardous environments corresponding to Class I, Division 2 or Class I,
Zone 2, the device must be installed in a cabinet or an enclosure. To comply with EU
Directive 94/9 (ATEX 95), this enclosure must meet the requirements of at least IP54
according to EN 60529.
Explosion hazard; failure to observe this information may result in death, severe injury, and
serious property damage.
Wires must not be connected to the device or disconnected from the device within a
flammable or combustible environment.
Explosion hazard; failure to observe this information may result in death, severe injury, and
serious property damage.
Do not disconnect live wires from the device if it cannot be ensured that an explosive
atmosphere is not present in the environment.
Explosion hazard; failure to observe this information may result in death, severe injury, and
serious property damage.
Replacement of components may impair suitability for Class I, Division 2 or Zone 2.
Fail-safe Module F‑CM AS‑i Safety ST (3RK7136‑6SC00‑0BC1)
Manual, 03/2017, A5E03957059020A/RS-AB/002
WARNING
WARNING
WARNING
WARNING
WARNING
2
9