Siemens SIMATIC ET 200SP Manual page 43

Parameter
Reintegration after
discrepancy error
Configuration status
In increments of 10 ms
1)
The setting cannot be changed.
2)
Safe outputs
You can activate up to 16 safe AS-i switching groups Open the settings for each required
switching group. Activate the output control and set the associated AS-i address.
Table 6- 5 Safe outputs: Switching group 0 to 15
Parameter
Activate output control
AS-i address
AS-i address switching
output
AS-i address error
acknowledgement
Configuration status
You will find additional information in the Programming and Operating Manuals:
● SIMATIC Safety - Configuring and Programming
(http://support.automation.siemens.com/WW/view/en/54110126)
● S7 Distributed Safety
(http://support.automation.siemens.com/WW/view/en/22099875/0/en)
Fail-safe Module F‑CM AS‑i Safety ST (3RK7136‑6SC00‑0BC1)
Manual, 03/2017, A5E03957059020A/RS-AB/002
Value
Test 0 signal
necessary on both
channels
2)
-
Value
Disable
•
Enable
•
1 ... 31
Output field, value is
calculated
automatically
Output field, value is
calculated
automatically
-
Assigning parameters / Setting the address space
Default setting
reassignment in
Test 0 signal
necessary on both
channels
-
Default setting
reassignment in
Disable
-
-
-
6.1 Parameters
Parameter Scope
RUN
- F-CM AS-i Safety ST
- (read-only)
Parameter Scope
RUN
No If this parameter is not
activated, none of the
following settings are
possible.
No Channel / safe
AS-i output slave
No Channel / safe
AS-i output slave
No Channel / safe
AS-i output slave
- (read-only)
43