Ds60 Display - Lennox CLIMATIC 60 User Manual

COMMUNICATION
DC60 DISPLAY
Function
The DC60 display is customized for the user to show a global operating overview of the unit and allow access to some settings. In
case of remote display, the cable length should not exceed 30 m.
Description
The DC60 terminal displays various status of the unit and offers the possibility to override the initial operating of the unit. Use the wheel
button to display the data desired in the big area. The small area specifi es the type of the data displayed.
Changeover mode
Unit mode
Status area
Big area
Small area
Set point "SET":
Specify the evaporator water set point calculated by CLIMATIC™ 60. The set point can be modifi ed directly by the DC60. Note that
the selected value will automatically be overwritten by CLIMATIC™ 60 when the actual zone will change (Z0 → Z6) if a scheduling
has been defi ned.
Unit number "UNIT":
Specify the evaporator water outlet temperature.
Outlet temperature "OUT":
Specify the evaporator water outlet temperature.
Inlet temperature "IN"
Specify the water evaporator inlet temperature.
Outside temperature "Air"
Specify the outside air temperature.
Alarm code "AL-"
Specify the active alarm(s) code(s).
Low pressure "LP-1"
Specify the low pressure of circuit 1.
High pressure "HP-1"
Specify the high pressure of circuit 1.
Low pressure "LP-2"
Specify the low pressure of circuit 2.
High pressure "HP-2"
Specify the high pressure of circuit 2.
Schedule zone
specify the schedule operating zone.
• 37 •
CL60-AC CHILLER-IOM-1011-E