Dc 50 Confort Display - Lennox CLIMATIC 50 User Manual

DC50 COMFORT DISPLAY
This display is mounted on the panel of the unit and can be also used as a remote controller; this display is
designed for non-technician user. This display gives information such as flow or pump status, set point and
outside air temperature. It does not allow access to detailed operating data.
It can be used to set or change the scheduling of the different time zones, the temperature set point for each
zone.
It also has the capacity to set a 3 hours override and to force the unoccupied mode or any of the different
time zones for a period of up to 7 days. It displays the real time clock and different faults signals.
Display
Type FSTN graphic
Back light: Green LEDs
Resolution 120x32 pixels
Power Supply
Voltage from main Climatic board
Max power: 0.8W
Remote Installation
The optional DC50 is designed to be mounted on the wall.
•
Fit the cable from the DT50 board through the back piece
•
Fasten the back piece to the wall using the rounded head screws supplied in the packaging
•
Connect the cable from the main board on the RJ12 plug on the back of the DC50 display
•
Fasten the front panel on the back piece using the flush head screws supplied
•
Finally fit the click-on frame
CLIMATIC 50, user manual – Chillers ranges
CL50-CHILLERS/IOM/0906-E
46
46