YASKAWA V1000 Installation Manual page 28

Signal Name
RYE Frequency Reference 2
Command Code Execute
RYF
Request
RY10
Reserved
to 13
RY14 Terminal S1 Function
RY15 Terminal S2 Function
RY16
Reserved
to 19
RY1A Fault Reset
RY1B
Reserved
to 1F
Note: 1. If making frequent setting changes, use RYD (Frequency Reference 1 flag) for setting the register.
Using RYE (Frequency Reference 2 flag) too often can shorten the performance life of the drive's
internal memory.
2. Although RYE and RYF are triggered by the rising edge of the signal, they are otherwise enabled
depending on the value that is input.
When switching between monitors using RYC (Monitor Reference), RYC needs to be turned off and
then back on again after the monitor code has been changed.
Drive → PLC
■
Device Signal Name
RX0 Forward Run
RX1 Reverse Run
Terminals MA, MB, MC
RX2
Function
YASKAWA ELECTRIC TOBP C730600 22B V1000 Option CC-Link Installation Manual
Sets the frequency in the remote register RW
parameter d1-01 (Frequency Reference 1) and as the
drive's main frequency reference at the same time.
Note: If the frequency reference is set to be provided
by the LED operator (i.e, b1-01 = 0), then
switching on RYE changes the frequency
reference.
Request to execute the command code.
Multi-function input: H1-01
Multi-function input: H1-02
Resets a drive fault
Table 8 Remote I/O Table (Drive → PLC)
ON: Forward Run Command Present (includes DC
Injection Braking)
OFF: No Forward Run Command
ON: Reverse Run Command Present
OFF: No Reverse Run Command (includes DC Injection
Braking)
Multi-function output: H2-01
8 CC-Link Data Table
Description
–
–
–
Description
Default
to
W1
All parameter settings
are saved when this
flag is switched on.
Triggered by the rising
edge of the signal.
Triggered by the rising
edge of the signal.
–
Function is disabled
when for the Forward
Run Command (H1-01
= 40).
Function is disabled
when for the Reverse
Run Command (H1-02
= 41).
–
–
–
Default
–
–
(H2-01 = E: Fault)
29