SYSTEM Page
Pressing the SYSTEM softkey displays the following
system and fuel calculation information:
MAN IN – Displays the engine manifold pressure in
inches of mercury (Hg).
TACHOMETER – Displays the current propeller speed
in revolutions per minute.
OIL PSI – Displays the engine oil pressure in pounds
per square inch (psi).
OIL °F – Displays the current oil temperature in degrees
Fahrenheit.
ENG HRS – Displays the engine hours (tach time)
VAC – Displays the vacuum pressure in pounds per
square inch.
FFLOW GPH – Displays the current fuel flow in gal-
lons per hour.
GAL USED – Displays the quantity of fuel used in
gallons.
FUEL QTY – Displays the current remaining fuel in
the system
VOLTMETER – Displays the main and essential bus
voltage.
AMMETER – Displays the main and standby battery
load in amperes.
The second-level softkeys are available by pressing the
SYSTEM softkey:
• RST USED
To reset the fuel used totalizer to zero:
1.
From the System Page, press the
softkey.
Pressing the engine page (ENGINE) softkey removes
the Lean or System Pages and displays the default engine
parameters.
RST USED
Garmin G1000 Cockpit Reference Guide for Cessna Nav III
Engine Indication System Operation
See the G1000 Engine Indication System Pilot' s Guide
for complete engine instrumentation procedures and op-
erational information.
Manifold Pressure
Gauge
System Information
Figure 5-5 Engine System Window (206 Shown)
SECTION 5 – MFD
Tachometer
Fuel Calculation Data
81