Electronic Checklists; Displaying The Checklist Page; Selecting A Procedure Group; Selecting A Checklist Within The Procedure Group - Garmin G1000 Reference Manual

5.6 ELECTRONIC CHECKLISTS

The G1000 Multi Function Display installed in
the Cessna Nav III provides Normal, Abnormal, and
Emergency checklists which allow a pilot to quickly find
the proper procedure on the ground and during each
phase of flight.
NOTE: The checklist information described in this
section is not intended to replace the checklist
information described in the Nav III Information
Manual and the Pilot Safety and Warning Supple-
ments document.
NOTE: Garmin is not responsible for the content
of the checklists. Checklists are created by the
aircraft manufacturer and cannot be edited by
the user. Additionally, modifications or updates
to the checklists are coordinated through the
aircraft manufacturer.

Displaying the Checklist Page

The Power-up Page displays the current checklist file
that is installed for the Nav III aircraft. If no checklist
is present, then the Power Up Page displays the text
"CHECKLIST FILE NOT PRESENT" and the CHKLIST
softkey is greyed out.
To select the Checklist Page:
1. From any page, press the CHKLIST softkey.

Selecting a Procedure Group

Checklist procedures are arranged in groups that relate
to importance. These groups might be designated as
Normal, Abnormal, and Emergency, but can be anything
deemed appropriate by the aircraft manufacturer.
Garmin G1000 Cockpit Reference Guide for Cessna Nav III
To select a procedure group:
1. Press the softkey.
CHKLIST
2. Turn the large FMS knob to select the 'GROUP'
field.
3. Turn the small FMS knob to select the desired
procedure and press the ENT key.
Selecting a Checklist within the Procedure
Group
1. Turn the large FMS knob to select the 'Checklist'
field.
2. Turn the large or small FMS knob to select the
desired checklist and press the ENT key.

Selecting a Checklist Item

Two methods are available to select a checklist item: (1)
pressing the ENT key; or (2) pressing the DONE softkey.
(1) Pressing the ENT key:
With the desired checklist displayed, turn the large
or small FMS knob to move up and down the checklist
and highlight an item with a hollow white rectangle. The
default color for non-selected checklist items is blue and
once the item is highlighted, the color turns white. To
select a checklist item that is highlighted, press the ENT
key. The selected item turns green in color again for ease
of identification, and then a check mark is placed in the
box next to the item. As an item is selected, the next item
is automatically highlighted for selection.
(2) Pressing the DONE Softkey:
Pressing the DONE softkey produces the same results
as pressing the ENT key.
NOTE: All warnings are displayed in yellow for
ease of identification.
SECTION 5 – MFD
77