DME Radio (optional)
The DME information window is displayed by press-
ing the PFD softkey followed by the DME softkey.
The DME information window is displayed above the
BRG1 information window. The DME information win-
dow displays the DME label, tuning mode (NAV1, NAV2,
or HOLD), frequency and distance. When a signal is in-
valid, the distance is replaced by "–.– – NM"
The pilot may select from three DME tuning modes:
• NAV1 – DME is from NAV1
• NAV2 – DME is from NAV2
• HOLD – Holds the last selected NAV radio fre-
quency.
When switching from NAV1 or NAV2 mode to HOLD
mode, the DME frequency remains at the last selected
NAV radio frequency until HOLD mode is removed.
NOTE: DME radio installation is optional.
Figure 2-21 DME Information Window
Garmin G1000 Cockpit Reference Guide for Cessna Nav III
DME Tuning Window (optional)
The DME Tuning window is displayed by pressing the
DME softkey. This window provides display and control
of the DME radio.
NOTE: The Radio Tuning window is only available
if a DME radio is installed.
Figure 2-22 Radio Tuning Window
To change the DME mode:
1.
From the Radio Tuning window, turn the large
FMS knob to highlight the DME mode field.
Turn the small FMS knob to display the selec-
2.
tion window. Turn the FMS knob to select the
desired mode and press the ENT key.
Figure 2-23 DME Selection Window
SECTION 2 – PFD
27