Function Group2 - Baldor VS1SM Installation & Operating Manual

7.3

Function Group2

Parameter #
7-10 Parameter Descriptions
Access Parameter Name, Value Range, Description and Preset Value
RW Jump Code (Range: 1-95)
Sets the parameter number to jump to within Function Group2.
Allows quick access to a desired parameter.
Preset Value:
RO Fault History 1 (Range: N/A)
Fault information for frequency, current and accel/decel at the fault time.
When a fault occurs during operation, it can be viewed with nOn in the
Drive Group. When the fault is reset it is moved to H1. Fault information
stored in H1 is moved to H2, H2 info is moved to H3 etc. H5 has the
oldest fault information.
Preset Value:
RW Fault History 2 (Range: N/A)
See H1.
Preset Value:
RW Fault History 3 (Range: N/A)
See H1.
Preset Value:
RW Fault History 4 (Range: N/A)
See H1.
Preset Value:
RW Fault History 5 (Range: N/A)
See H1.
Preset Value:
RW Reset Fault History (Range: 0-1)
1- Clears H1, H2, H3, H4 and H5 fault history locations.
Preset Value:
RW Dwell Speed (Range: F23 to 400Hz)
When a run command is issued, dwell frequency is applied to the motor for
H8 time. Then normal accel to speed setpoint will occur.
H8 must be set to a value between F21 and F23.
Preset Value:
RW Dwell Time (Range: 0-10sec)
Sets the duration of the dwell operation (0.0=no dwell operation).
Preset Value:
RW Skip Frequency (Range: 0=Off, 1=On)
Sets whether or not certain frequencies will be skipped to help prevent
undesirable resonance and vibration on the structure of the machine.
Preset Value:
RW Skip Frequency Low Limit 1 (Range: 0-400Hz)
Sets the lower limit of frequency range 1 to skip.
Preset Value:
1
N/A
N/A
N/A
N/A
N/A
0
5.00
0.0
0
10.00 Parameter is only displayed when H10=1.
MN761