System Speed Dial Numbers - Comdial DXP Attendant Manual

Attendant Features

System Speed Dial Numbers

You can store up to 500 system speed dial numbers at your attendant telephone.
Typically, these are numbers that are frequently called by many different users
and emergency numbers that you want readily available to everyone. Distribute a
list of these stored numbers to the system users.
To program system speed dial numbers,
•
1. RECORD the following information on the system speed dial
record sheet:
• the dialing code of the storage location (000–999),
• the line that will be used to access each outside number,
• the telephone numbers you are storing.
2. PRESS INTERCOM.
3. DIAL
4. DIAL code for storage location (000–999).
5. DIAL code to make your speed dial route selection choice from
the following list:
• DIAL
• DIAL
• DIAL
• DIAL
• DIAL
6. DIAL the number to be stored (up to 32-digits long). To store a
pause, press HOLD, then continue dialing. Press TAP to store a
hookflash, then continue dialing.
7. PRESS TRNS/CNF to store number.
8. DIAL next storage location, line choice and speed dial number,
AND PRESS TRNS?CNF.
9. REPEAT previous step until all numbers are stored.
10. PRESS SPEAKER to end.
102
*#0*02
1# 99#
to
must be added if number is less than three digits),
100 128
to
801 816
to
000
to select prime or last line used,
800
to select intercom.
.
to select lines 1–99 (
to select lines 100–128,
to select line groups 1–16,
GCA70-250
#
Attendant Manual