Monitoring A Conversation Between Two Telephones (Service Observing); Switching The Dialing Mode Between Pulse And Tone - Comdial DXP Attendant Manual

Other Features
Monitoring A Conversation
Between Two Telephones (Service Observing)
If your LCD speakerphone provides the installer–programmed Service Observing
feature, you can use it to monitor a conversation or activity at another telephone
in an undetected manner. You can use this feature while you are in the
speakerphone mode or off-hook.
To monitor another station at any time,
•
1. PRESS INTERCOM.
2. DIAL
3. DIAL extension number of telephone to be monitored.
4. PRESS SPEAKER to end monitoring.
Your system installer may also program a dedicated SERVICE OBSERVE button
that may be used in place of the feature access code.
Switching The Dialing Mode
Between Pulse And Tone
If the telephone service in your locality is pulse (rotary dialing), the installer
arranges your telephone to dial in this manner. If you need to send tones during a
dialing sequence (for example, to send bank-by-telephone tones), you can
convert to tone dialing mode while dialing. The system will switch back to pulse
dialing when you end your call.
You can store a
from pulse to tone where needed in a number sequence.
To convert to tone dialing at any time during dialing or
•
while on an active call,
1. DIAL
88
#03
.
#
as part of a speed dial number to cause an automatic switch
#
.
GCA70-250
Attendant Manual