System Telephone Naming - Comdial DXP Attendant Manual

Attendant Features

System Telephone Naming

You can assign a name that is either a personal name or a group name to each
system telephone. This name can be up to seven letters in length and will show
up in the user's display and/or in the called party's display. You can compose a
valid name from any alpha-numeric character; however, the first character of a
display name must be an alphabetic character. Typical names could be SRVC,
MKTG 1, and K SMITH.
When appropriate programming action has been taken by the installer, a second
line showing the personal intercom number of the calling station is also
displayed.
Name the system telephones as follows:
•
1. USE letter code table (page 92) to compose names for all tele-
phones requiring them (up to seven letters per name are allowed)
and record the names on the station name record (page 97).
2. PRESS INTERCOM.
3. DIAL
4. SELECT telephone to be named by dialing the extension number
• DIAL number plus
5. DIAL
6. DIAL 2-digit codes that correspond to letters in name (station
names must begin with a letter).
7. DIAL
8. REPEAT steps 4 through 7 until all telephones are named.
9. PRESS SPEAKER to end.
96
*#0*53
#
4-digits).
#
to clear any current entry.
#
to save name or save cleared name.
.
if extension number is less than
GCA70-250
Attendant Manual