Canon iPF780 Series Service Manual page 48

Chapter 1
[System Setup]
[Prep.MovePrinter]
[Admin. Menu]
[Printer Info]
1-38
Setting Item
[Erase HDD [High Speed] Delete the file management information of the saved data in the HDD.
Data]
[Secure High Overwrite the random data in the whole of the hard disk drive.
Spd.]
[Secure] Overwrite 00 and FF and random data in the whole of the hard disk drive once at a time.
Execute the verify check whether the data has written correctly to the hard disk drive.
[Output [Print] Select the output method of jobs sent from software other than the printer driver. This can be
Method] set from the printer if you are using a printer driver.
[Print (Auto
Select [Print] to print normally. Select [Print (AutoDel)] to print and delete the data in hard disk.
Del)]
Select [Save: Box XX] to save to box without printing.
[Save: Box
XX]
[Print After Recv] Setting of jobs sent from software other than the printer driver. This can be set from the printer
if you are using a printer driver. Select [On]to print after saving.
[Save: Common Box] Select [Off] to print without saving to a common box.
[Show Job Log] Selecting off prevents display of the log in Job Menu > Job Log. Additionally, the log is not
printed if you choose Job Menu > Print Job Log. Note that because job logs are not collected,
the Status Monitor accounting functions will not work correctly.
[Standard] Select when moving the printer. Follow the instruction on the screen and perform the necessary
process.
[Limited]
This is not displayed when displaying a warning message about the amount remaining
maintenance cartridge.
[Chg.Admin.Pswd] Set a password to restrict displaying/setting of menus as follows. Allowed value is from 0 to
9999999.
- Allow only administrator to display/set
[IPv4]
[Change Password]
[Init.Admin.Pswd]
- Allow administrator to display/set and non-administrator to display only
[Interface Setup] (exclude [IPv4])
[Date & Time]
[Date Format]
[Time Zone]
[Use RemoteUI]
[Reset PaprSetngs]
[Save: Shared Box]
[Init.Admin.Pswd] Press [OK] to return the [Administrator Menu] password to factory default.
[Paper Info] Display the currently set paper type, size and printer settings.
[Ink Info] Display ink levels and maintenance cartridge capacity.
[Head Info] Display the Printhead information.
[System Info] Display the firmware version, serial number, and interface information.
[Error Log] Display the most recent error messages (up to 5).
[Use Situation] Display the total area and duty counter printed.
Description/Instructions