Canon iPF780 Series Service Manual page 44

Chapter 1
[GL2 Settings] [Quality
Manager]
[Paper
Manager]
1-34
Setting Item
[Color Mode] [Monochrome
]
[Color (CAD)
1]
[Color (CAD)
2]
[Color (CAD)
3]
[Color (CAD)
4]
[Color (CAD)
5]
[Print Quality]
[Input Resolution]
[Print (Economy)]
[Paper Source]
[Margin]
[Oversize]
[Conserve Paper]
[Auto Rotate]
[Enlarge/Reduce]
[Print centered]
[Standard cut]
[Nesting] [Use Nesting] Select [On] to print pages when they are tiled fully to the roll width, instead of printing them
[Nesting
WaitTime]
[Cut Lines]
Description/Instructions
Print by the monochrome.
Print by the standard color.
Print by the bright color.
Print by the color emulated the Canon iPF500/iPF600/iPF700/iPF510/iPF610/iPF710/iPF605/
iPF720/iPF810/iPF820.
Print by the color emulated the HP Designjet 500/800.
Print by the color emulated the HP Designjet 1000.
Select the print quality.
Choose the printer input resolution from between [600dpi] and [300dpi].
Print with a lower grade of print than normal, but with less ink consumption. Select [ON] to
economize on inks.
Select how to feed paper for printing on the HP-GL/2.
Set the top/bottom and left/right margins of the paper. For cut-sheet, the trailing edge margin is
23mm.
However, if the leading edge margin is set with [Paper Details], that value has priority.
Set the positions of the margins.
Select [On] to adds the margins to the outer edge of the rendering region set by the [Detect img
size] function. (This corresponds to the case where the [PaperSizeProcess 1] function in the old
menu is set to Off)
Select [Off] to sets the margins inside the rendering region taking the size set by the [Detect
img size] function as the rendering region. Areas that overlap with the margin are not printed.
(This corresponds to the case where the [PageSizeProcess 1] function in the old menu is set to
On)
Print by economizing on paper.
If a document has its long side shorter than the roll width, the page rotates by 90 degrees
automatically to economize on paper. If a document contains horizontally long data such that
it has its long side longer than the roll width and its short side shorter than the roll width, the
page rotates 90 degrees to print within the boundaries of the paper.
HP RTL cannot rotate.
In case of HP RTL image, the image may be truncated or a blank paper may be ejected because
the image cannot be rotated even if the paper size is rotated by 90 degrees. In that case, set [Auto
Rotate] to [Off].
Set the enlargement or reduction.
Select [Off] to enlargement and reduction are not executed.
Select [Specify scaling] to prints at the specified magnification. You can specify the
magnification in the range of 25 to 400%.
Select [Fit to paper] to print at enlargement or reduction ratio to fit the paper size.
Set the printing position on the paper.
Select [On] when printing on roll paper, prints in the center of the width of the roll paper. When
printing on cut paper, prints in the center of the paper.
Select [Off] to print at the top left of the paper.
Select [On] to print depending on the standard paper size.
one by one.
Set the time to elapse before printing.
Select [On] to print perforated lines between pages.