Canon iPF780 Series Service Manual page 41

4. Main Menu Settings
Main menu items are described in the following tables.
[Paper Menu]
[Load Paper]
[Eject Paper]
[Chg. Paper Type]
[Chg. Paper Size]
[ManageRemainRoll]
[Pap. Detail Set]
(The paper type is displayed
here.)
[Pap. Detail Print]
[Keep Paper Type]
Setting Item
[Head Height]
[Crooked Chk Lv.]
[Cutting Mode]
[Cut Speed]
[Trim Edge First]
[CutDustReduct.]
[VacuumStrngth]
[Scan Wait Time]
[Roll DryingTime]
[NearEnd RollMrgn]
[NearEnd Sht Mrgn]
[BordlessOversize]
[Width Detection]
[Return Defaults]
Description/Instructions
Select and load either cut sheet or roll media.
Remove currently loaded paper.
Change currently set paper type.
Change currently set paper size.
Choose On to print a barcode at the end of a roll before you remove it. The printed barcode can
be used in managing the amount of roll paper left. ChooseOff if you prefer not to print the
barcode.
Adjust the Printhead height.
If you print on the paper that has an irregular width, choose Loose for a higher skew detection
threshold, or choose Off to disable skew detection. However, if paper is loaded askew when
detection is Off, note that paper jams or Platen soiling may occur.
Select whether to use standard round blade cutter or not.
Select [Automatic] to cut paper after printing. Select [Manual] to print a line at the cut position
after printing without cutting. Select [Eject] to prevent the printout from dropping until the ink
dries after printing.
Choose the cutting speed. If you use adhesive paper, choosing Slow helps prevent adhesive
from sticking to the cutter and keeps the cutter sharp.
If a roll is loaded, the end of the paper will be cut.
Choose On to reduce the amount of debris generated when cutting film and similar media by
printing a line at the cut position. This option reduces the amount of debris given off after
cutting. It also helps prevent adhesive from sticking to the cutter and keeps the cutter sharp if
you use adhesive paper.
Specify the level of suction that holds paper against the Platen.
Specify the time to wait for the ink to dry between each scan in bidirectional printing, in
consideration of how quickly the ink dries. Note that printing will take longer if you specify a
wait time.
Specify the time to wait for the ink to dry for each sheet.
Specify the minimum margin at the leading edge of roll paper to ensure better printing quality
at the leading edge.
Note that if you choose 3mm, it may lower the printing quality at the leading edge and affect
feeding accuracy. The printed surface may be scratched, and ink may adhere to the leading
edge. It may also cause the Platen to become soiled.
Specify a margin at the leading edge of sheets to ensure better printing quality at the leading
edge.
Note that if you choose 3mm, it may lower the printing quality at the leading edge and affect
feeding accuracy. The printed surface may be scratched, and ink may adhere to the leading
edge.
Select the margin during borderless printing.
Set to print from desired position such as when printing inside a frame.
Select [Off] to disable paper width and skew detection. If paper is loaded askew, paper may jam
or platen soiling may occur.
Choose OK to restore Paper Details to the factory default values.
Print the paper settings set with [Paper Details].
Select [On] to continue using the same type of paper.
Chapter 1
1-31