Print the nozzle check pattern before making preparations for transporting the printer, pint the nozzle check pattern again after installing the printer at the new lo-

cation, and then compare the two printouts.

If any problem such as nozzle clogging cannot be resolved by printhead cleaning, replace the printhead with a new one.

This section describes how to transport the printer.

The procedure depends on the mode of transportation. Select the appropriate transportation level from the following transportation modes.

1. Transportation mode

- Moving the printer on the same floor with no difference in grade (without tilting the printer)

- Moving the printer on floor where there is difference in grade or transporting by truck (by tilting the printer)

- Transporting by plane or ship or others or transporting in low temperature environment such as below freezing (tilting direction of printer is unpredictable)

When lifting or moving the printer, be sure to hold the left and right and rear carrying handles of the printer. The printer may be unsteady if you hold it at other

positions, which poses a risk of injury from dropping the printer.

The printer main unit weights approximately 56 kg. When moving the printer, have at least three people hold it from left and right and rear side taking care not to

hurt their back.

F-3-1

F-3-2

Chapter 3

0031-2550

3-1

Table of Contents