Control Terminals; Diagnostics - Lenze 8400 protec Hardware Manual

6 Electrical installation − HighLine/StateLine version

Control terminals

Diagnostics

6.6 Control terminals
6.6.1 Diagnostics
The following can be optionally connected to the X70 diagnostic interface:
USB diagnostic adapter E94AZCUS
ƒ
In combination with the Lenze PC software »Engineer«, the diagnostic adapter serves
to make comprehensive settings via dialogs, e.g. for initial commissioning.
EZAEBK2001diagnosis terminal
ƒ
The diagnosis terminal comprises the keypad including housing and a connecting
cable.
The diagnosis terminal can be used to control or change individual settings. In a quick
commissioning menu, the basic settings of the controller can be parameterised using
the diagnosis terminal.
The X70 plug is located behind the service hatch. Apply a little pressure to open the service
hatch and push the two plastic bars down. Tools are not required.
After using the diagnostic interface, remove the connecting cable at X70 and completely
close the service hatch.
X70 − diagnostic interface
Pin Signal
1 ... 10 internal
92
Description
Type RJ69, 10−pole, socket
8400HLC009
Terminal for diagnosis terminal or diagnostic adapter
l
Data
EDS84DPS424 EN 5.0