Communication; Can Port - Lenze 8400 protec Hardware Manual

3.5

Communication

The available combinations of communication and connection system can be seen from
the table.
Type code characteristics
Communication
(fieldbus)
1)
CANopen
C
PROFIBUS
P
PROFINET / EtherNet/IP
R / G
3.5.1

CAN port

Detailed information on CAN can be found in the software manual.
CAN on board
"CAN on board" is only suited for short point−to−point connections between two
controllers, e.g. for synchronisation. Pay attention to notes on EMC−compliant wiring and
short cable lengths as there is no isolation towards the control electronics of the controller.
Node address and baud rate must be parameterised using the »Engineer«.
CANopen
CANopen is executed as isolated fieldbus and suited for multiple−node networks.
In case of fieldbuses, node address and baud rate can be set using the DIP switch under the
service hatch or parameterised using the »Engineer«.
EDS84DPS424 EN 5.0
Input /
output area
configuration
Push−pull
1 −
5 −
1 −
3 −
5 −
7 −
1)
1 −
þ
2
3 −
þ
4
5 −
þ
6
7 −
þ
8
þ designed
1)
cannot be combined with safety options 20 and 30
2)
cannot be combined with safety option 30
3)
not in StateLine version
− impossible
l
Product description
Communication
Connection system version
Fieldbus SSI
3)
M12 M12
þ
−
þ þ
þ
−
þ
−
þ þ
þ þ
þ
−
− −
þ
−
− −
þ þ
þ
−
þ þ
þ
−
3
CAN port
Analog input CAN on board
M12 M12
þ
−
− −
þ
−
þ þ
2)
− −
þ
2)
−
þ
−
þ
−
þ þ
2)
þ þ
2)
− −
− −
þ
2)
−
þ
2)
−
27