Replacing The Plastic Cover - Agilent Technologies 8453 Operator's Manual

1 Disconnect the multicell transport.
2 Remove the multicell transport from the sample compartment. See "Removing
3 Remove the cell holder from the multicell transport, see "To Remove the Cell
4 Unscrew the 6 housing screws located at the rear side of the cell holder.
Figure 11
Housing screws
5 Open the tubing clamp and take apart the two plastic covers. See Figure 12.
Figure 12
Maintenance and Repair

Replacing the Plastic Cover

Replacing the Plastic Cover
If the plastic cover is defective, it should be replaced.
To Remove the Plastic Cover
the Multicell Transport from the Spectrophotometer" on page 25.
Holder" on page 26.
Removing the Plastic Covers
Plastic Covers
36
Tubing clamp