Cisco Headset 500 Series Setup - Cisco 8841 User Manual

Cisco Headset 500 Series Setup

The adapter makes it easy to use basic and advanced call features. With a single tap of the adapter
you can answer an incoming call. A quick double tap, and an incoming call is sent to your voicemail account.
Tap once and enter the phone number using your phone keypad to make a call. Another single tap places your
active call on hold. Press
The Cisco USB adapter is supported on Cisco IP Phone 8851, 8861, and 8865 with Multiplatform Firmware.
To check your phone model, press Applications
Product name field shows your phone model.
The Cisco Headset 531 and Cisco Headset 532 require Multiplatform Firmware Release 11.1(2) and higher.
Upgrade your phones to the latest firmware before using these headsets.
Figure 4: Cisco Headset USB Adapter
Cisco Headset 500 Series Setup
The Cisco Headset USB Adapter is available for use with the Cisco Headset 531 and 532. With the USB
adapter, you can test your headset, plus customize your bass and treble, gain or microphone volume, and
sidetone or feedback settings. The adapter also retains your settings when you swap the headset among phones.
Note
A factory phone reset does not affect the headset settings.
Adjust Your Headset Bass and Treble
Customize your headset by adjusting the bass and treble. If you prefer a headset with more bass, then adjust
toward the warm setting. If you prefer more treble, then adjust toward the bright setting.
Procedure
Step 1
Press Applications
Step 2 Select Status.
Step 3
Select Accessories.
Step 4 Navigate Setup > Speaker > Tuning.
Step 5
Press the Navigation cluster, left or right, to adjust the tuning.
Step 6 Press Save to apply and retain your setting.
Cisco IP Phone 8800 Series Multiplatform Phones User Guide
82
and hold for 2 seconds, and your call ends.
.
, press Status, and select Product information. The
Accessories
button,