Wacker Neuson DPU 4545 Operator's Manual page 35

NOTICE
Perform oil change and oil level check with warm exciter oil. Machine must not be in use
and must be level.
Item Designation
1 Screw plug
NOTICE
Lay an impermeable film on the working surface to protect against escaping oil.
1. Tip the machine to the side of the filler boring and support it.
2. Place an appropriate collecting container below the filler boring.
3. Remove dirt accumulation within the range of the filler boring.
4. Unscrew the screw plug from the filler boring and allow the waste oil to drain completely.
NOTICE
Collect escaping or overflowing oil and dispose of with the waste oil in an environmentally
friendly manner in accordance with the existing rules and regulations of the legislative
body.
5. Tip the machine to the other side and support it.
NOTICE
Only fill with the prescribed volume of oil.
6. Fill new oil (see chapterTechnical Data for the exciter oil type and volume) in the filler boring. Use an
appropriate and clean filling container.
7. Place the machine level on the ground.
8. Screw the screw plug with seal ring into the filler boring. The torque setting is 100 Nm.
100_0202_mt_0008.fm
1, 2
Item Designation
2 Filler boring
9 Maintenance
35