Use Of Induction Hob - Elba 345-004 Instructions For The Use

2

USE OF INDUCTION HOB

Notes:
• Each selection (by pressing one of the keys) is
indicated by an acoustic signal (beep).
• User interface initial calibration: this feature is for
the keyboard calibration, to adapt the sensibility
of the keys to the final mechanical, environmental
and user conditions. Any time the cooktop is con-
nected to the electrical supply or after a power
failure (that generates a reset in the user interfa-
ce), the first time the Key-Lock
sensibility of the keyboard is readjusted.

The first touch of the Key-Lock
in certain condition: do not use gloves, use a cle-
ar finger.

It is also important to consider that the calibration
process requires a low level of ambient light in
the area of the touch keys. If the environmental
light conditions are excessive (e.g. halogen hood
light/s on), the user interface calibration is su-
spended and the cooking zones displays show
F L
" " and " " alternating - error message "
the correct light conditions will be recovered.

In this case the direct environmental light/s must
be switched off before calibrating the cooktop;
then, after completing the process, the light/s can
be switched on again.
• The touch control is switched off automatically
(and a warning beep sounds every 10 seconds):
– if one or more keys are touched for more
than 10 seconds;
– if an object is positioned on the touch control
area;
– in the case of spillage of liquids on the con-
trol keys.
• When the touch control reaches an ambient tem-
perature above a preset temperature the heating
elements are automatically switched off (the di-
splays show "
sage " F "). In this case let the cooktop cool down
before using again.
6
F " and " " alternating - error mes-
is touched the
must be done
FL
") until